Engine General Information and Diagnosis: 1A-3
3) Start the engine or crank the engine for more than 4
seconds.
4) Turn the special tool’s switch ON.
5) Check the DTC to determine the malfunction part.
Refer to “DTC Table in related manual”.
Special tool
(A): 09930–82720 (Mode select switch)
6) After repairing the trouble, turn OFF the ignition
switch and turn ON again. If DTC is indicated (C00),
the malfunction is cleared.
NOTE
• Even though DTC (C00) is indicated, the
previous malfunction history DTC still
remains stored in the ECM. Therefore,
erase the history DTC memorized in the
ECM using SDS.
• DTC is memorized in the ECM also when
the wire coupler of any sensor is
disconnected. Therefor, when a wire
coupler has been disconnected at the time
of diagnosis, erase the stored history DTC
using SDS. Refer to “Use of SDS Diagnosis
Reset Procedures in related manual”.
7) Turn the ignition switch OFF and disconnect the
special tool from the mode select switch.
8) Reinstall the right frame cover.
Special Tools and Equipment
Special Tool
B817H21108001
(A)
I718H1110006-04
I817H2110001-01
09930–82720
Mode select switch
)(Page 1A-2) / )(Page 1A-
2) / )(Page 1A-3)
To Next Page
Loading...
