Suzuki k8 gsx1300r - Page 5

Hayabusa-Zone.com
Bikeland.org
- 5/12-
Figure 3
Correct
Correct
Correct
Figure 4
REROUTING
1. Reroute the ignition switch lead wire correctly (Figure 3 and Figure 4). The ignition switch
lead wire should not be covered by the other wire harnesses.
2. Turn the handlebars back and forth to verify that the steering operates smoothly and the
wiring harness does not become kinked or pinched.
3. Proceed to PUNCH MARK AT VIN on page 8.
90
0
90
0
Correct Routing
The ignition switch
lead wire is routed in
front of the right
switch lead wire.
Front side
ªª
ªª
ª
Correct Gray Tape
Location
Gray tape is visible on
both sides of clamp.