Suzuki K9K - Crankshaft Pulley Installation and Final Timing Checks (K9 K Engine); Crankshaft Pulley Installation Procedure; Crankshaft Pulley Bolt Tightening Specification

ENGINE MECHANICAL (K9K ENGINE) 6A2-41
18) Turn crankshaft two revolutions clockwise, and stop it just
before aligning slit (1) of camshaft pulley (2) with hole (3) of
cylinder head.
19) Insert special tool (A) into TDC pin hole as shown in figure.
Special tool
(A): 09919-58110
20) Turn crankshaft pulley clockwise until crankshaft touches
special tool (A).
21) Check that special tool (B) inserts holes of timing belt pulley
and cylinder head smoothly.
If not, remove timing belt and return to step 4).
Special tool
(B): 09919-58120
22) Install crankshaft pulley as follows.
a) Lock flywheel using special tool (C).
Tightening torque
(C): 09916-98110
b) Remove crankshaft pulley bolt.
c) Install crankshaft pulley (1) and washer, and tighten new
crankshaft pulley bolt (2) as follows.
i) Tighten crankshaft pulley (1) bolt to 120 N·m (12.0 kg-m,
87.0 lb-ft).
ii) Retighten crankshaft pulley bolt to 95°.
Tightening torque
Crankshaft pulley bolt (a): Tighten 120 N·m (12.0 kg-m,
87.0 lb-ft) and 95° by the specified procedure
(C)