7-65
6. To reinstall the wheel assembly,
reverse the sequence described
above.
7. After installing the wheel, apply the
front brake several times to restore
the proper lever stroke.
Front axle tightening torque:
100 N·m (10.0 kgf-m, 72.5 lbf-ft)
Front axle holder bolt
tightening torque:
33 N·m (3.3 kgf-m, 24.0 lbf-ft)
WARNING
Failure to extend brake pads after
installing the wheel can cause poor
braking performance and may result
in an accident.
Before riding, “pump” the brake
lever repeatedly until the brake pads
are pressed against the brake disks
and proper lever stroke and firm feel
are restored. Also check that the
wheel rotates freely.
WARNING
If the bolts and nuts are not properly
tightened, the wheel can come off,
causing an accident.
Be sure to tighten the bolts and nuts
to the specified torque. If you do not
have a torque wrench or do not know
how to use one, ask your authorized
Suzuki dealer to check the bolts and
nuts.
To Next Page
Loading...
