Suzuki WagonR - Rear Seats

2-16
67L-74E
BEFORE DRIVING
67LH3-74E
To raise the front head restraint, pull
upward on the restraint until it clicks. To
lower the restraint, push down on the
restraint while holding in the lock lever. If a
head restraint must be removed (for clean-
ing, replacement, etc.), push in the lock
lever and pull the head restraint all the way
out.
Rear Seats
Head Restraints (if equipped)
Head restraints are designed to help
reduce the risk of neck injuries in the case
of an accident.
NOTE:
It may be necessary to fold forward the
seatback to provide enough overhead
clearance to remove the head restraint.
Adjust the head restraint to the position
which places the center of the head
restraint closest to the top of your ears. If
this is not possible for very tall passengers
adjust the head restraint as high as possi-
ble.
67LH023
To raise the rear head restraint, pull
upward on the restraint until it clicks. To
lower the restraint, push down the restraint
while holding in the lock lever. If a head
restraint must be removed (for cleaning,
replacement, etc.), push in the lock lever
and pull the head restraint all the way out.
When installing a child restraint system,
raise the head restraint to the most upper
position.
Folding Rear Seat
The rear seat of your vehicle can be folded
forward to provide additional cargo space.
To fold the rear seat forward:
67LH024
1) Hook the webbing of the outboard lap-
shoulder belts in the belt hangers.
2) Lower the head restraint (if equipped)
fully.
WARNING
• Never drive the vehicle with the
head restraints removed.
• Do not attempt to adjust the head
restraint while driving.
EXAMPLE
CAUTION
• When you move a seatback, make
sure the belt webbing is hooked in
the seat belt hangers so the seat
belts are not caught by the seat-
back, seat hinge, or seat latch. This
helps prevent damage to the belt
system.
• Make sure the belt webbing is not
twisted.
EXAMPLE