Suzumar DS-320 - 2.5 Assembly for DS-290;320;360;390;420

2
floor no.○
1
.
2
3
5
4
6
2-3
2.5.1 Insert floor board no.○
1
onto bow of boat.
2.5.2 Insert floor board no.○
4
under floor guard ○
5
on transom ○
6
of boat.
2.5.3 Insert floor board no.○
2
into floor board No.○
1
.
2.5.4 Insert floor board no.○
3
into floor boards No.○
2
and ○
4
, press down until
flat.
2.5.5 Inflate the air chambers up to ¾ of their capacity.
2.5.6 Slide an oar between ground and bottom of the boat to rise up slightly
the sides of the floor boards. Attach side stringer. Repeat the
procedure on opposite side of the boat.
2-4
For boats DS-360 and DS-390 and DS-420 with four stringers, start
with one long, one short joiner on one side and with one short and one
long on the other side (asymmetric). [2-5]
DS-360/390/420
2-5
2.5.7 Install the wooden seat.
2.5.8 Finish inflating the air chambers on tube to pressure 0.25 bar, one after
the other in order to maintain equal amount of air. DO NOT inflate any
chamber to full capacity at one time.