Svan SVI631FZ - Booster and Double Booster Function; Timer

28
Booster and double booster function
Booster [ P ] and double booster [ ] grant a boost of power to the selected heating zone.
If this function is activated the heating zones work during 10 minutes with an ultra-high power.
This is foreseen for example to heat up rapidly big quantities of water, like noodles
• Start up / Stop the booster:
Action Control panel Display
Start up the booster Slide to the end of the “SLIDER” [ P ]
Or press directly on the end of
the “SLIDER”
Stop the booster Slide on the “SLIDER“ [ 9 ] to [ 0 ]
• Start up / Stop double booster
Action Control panel Display
Start up the booster Slide to the end of the “SLIDER” [ P ]
Or press directly on the end of
the “SLIDER”
Start up double booster Re-press key [ P ] [ and P ]
Stop the double booster Slide on the “SLIDER“ [ P ] to [ 0 ]
Stop booster Slide on the “SLIDER“ [ 9 ] to [ 0 ]
• Power management:
When it comes to the power, the cooking zones are running by pairs and cannot exceed an
overall maximum of power. If the selected heating levels for both zones exceed the maximum
available amount of power, the power management function is automatically reducing the power
from one of these zones. The display of this zone is first blinking; the level is then automatically
reduced to the highest suitable position.
Heating zone selected The other heating zone: (example: power level 9)
[ P ] is displayed [ 9 ] goes to [ 8 ] and blinks
Timer
The timer is able to be used simultaneous with all heating zones and this with different time
settings (from 0 to 999 minutes) for each heating zone.
• Setting and modification of the cooking time:
Action Control panel Display
Select the power level slide on the “SLIDER“ [ 1 ] to [ P ]
Select theTimer Press simultaneously key [ - ] and [ + ] Timer display on
from the timer until the
desired display is on
Decrease the time Press key [ - ] from the timer [ 60 ] to 59, 58...
Increase the time Press key [ + ] from the timer Time increase
After a few seconds, the [ min ] display stops with blinking.
The time is confirmed and the timer starts.
• To stop the cooking time:
Action Control panel Display
Select the Timer Press simultaneously key [ - ] and [ + ] Timer display on
from the timer until the
desired display is on
Stop the time Press key [ - ] from the timer [ 000 ]
If several timers are activated, repeat the process.