EasyManua.ls Logo

Svan SVL641 - Troubleshooting

Svan SVL641
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN - 25
9. TROUBLESHOOTING
Repairofyourmachineshouldbecarriedoutbyanauthorisedservicecompany.Ifyour
machinerequiresrepairorifyoucannotsolveanissuewiththeinformationprovided
below, then you should:
• Unplugyourmachinefromthemainspowersupply.
• Turn off the water supply.
FAULT POSSIBLE CAUSE TROUBLESHOOTING
Yourmachinedoesnotstart.
Machinenotpluggedin. Plugmachinein.
Fuses are faulty. Replace the fuses.
Nomainspowersupply. Checkmainspower.
Start/Pause button not pressed. Press the Start/Pause button.
Programmedial‘stop’position. Turntheprogrammedialtothedesiredposition.
Themachinedoorisnot
completely closed.
Closethemachinedoor.
Yourmachinedoesnot
intakewater.
Watertapisturnedoff. Turn tap on.
Waterinlethosemaybetwisted. Checkwaterinlethoseanduntwist.
Waterinlethoseclogged. Cleanwaterinlethosefilters.(*)
Inletfilterclogged. Cleantheinletfilters.(*)
Themachinedoorisnot
completely closed.
Closethemachinedoor.
Yourmachinedoesnot
dischargewater.
Drainhosecloggedortwisted.
Checkthedrainhose,theneithercleanor
untwist.
Pumpfilterclogged. Cleanthepumpfilter.(*)
Laundryistootighlypacked
togetherinthedrum.
Spreadyourlaundryinthemachineevenly.
Yourmachinevibrates.
The feet have not been adjusted. Adjust the feet. (**)
Transitboltsfittedfor
transportationhavenotbeen
removed.
Removethetransitboltsfromthemachine.(**)
Smallloadinthedrum. Thiswillnotpreventoperationofyourmachine.
Yourmachineisoverloadedwith
laundryorlaundryisunevenly
spread.
Do not overload the drum. Spread laundry evenly
inthedrum.
Yourmachinerestsonahard
surface.
DonotsetupyourWashingMachineonahard
surface.
Excessivefoamisformedin
the detergent drawer.
Excessiveamountofdetergent
used.
Press the Start/Pause button. To stop the foam,
diluteonetablespoonofsoftenerinto1/2litreof
waterandpourintothedetergentdrawer.Press
theStart/Pausebuttonafter5-10mins.
Wrong detergent used.
Onlyusedetergentsproducedforautomatic
WashingMachines.
Unsatisfactorywashing
result.
Yourwashingistoodirtyforthe
programme selected.
Usetheinformationintheprogrammetablesto
selectthemostappropriateprogramme.
Amount of detergent used
insufficient.
Usetheamountofdetergentasinstructedonthe
packaging.
Thereistoomuchlaundryinyour
machine.
Checkthatthemaximumcapacityforthe
selected programme has not been exceeded.

Related product manuals