Svan SVL843X - Automatic Fault Warnings and What to Do

EN - 28
FAULT POSSIBLE CAUSE TROUBLESHOOTING
Unsatisfactorywashing
result.
Hard water.
Increasetheamountofdetergentfollowingthe
manufacturer’sinstructions.
Yourlaundryistootightlypacked
togetherinthedrum.
Checkthatyourlaundryisspreadout.
Assoonasthemachineis
loadedwithwater,water
discharges.
Theendofwaterdrainhoseistoo
lowforthemachine.
Checkthatthedrainhoseisatasuitableheight.
(**) .
Nowaterappearsinthe
drumduringwashing.
Nofault.Waterisintheunseen
part of the drum.
. . . . . . . . . . . . . . . . . . . . .
Laundry has
detergentresidue.
Non-dissolvingparticlesofsome
detergents may appear on your
laundryaswhitespots.
Performanextrarinse,orcleanyourlaundrywith
abrushafteritdries.
Grey spots appear on the
laundry.
Thereisuntreatedoil,creamor
ointmentonyourlaundry.
Usetheamountofdetergentasinstructedonthe
packaginginthenextwash.
Thespincycledoesnottake
place or takes place later
than expected.
No fault. The Unbalanced load
controlsystemhasbeenactivated.
TheUnbalancedloadcontrolsystemwilltryto
spreadyourlaundry.Thespinningcyclewillbegin
onceyourlaundryisspread.Loadthedrum
evenly for the next wash.
(*)Seethechapterregardingmaintenanceandcleaningofyourmachine.
(**)Seethechapterregardinginstallationofyourmachine.
10. AUTOMATIC FAULT WARNINGS AND WHAT TO DO
YourWashingMachineisequippedwithabuilt-infaultdetectionsystem,indicatedbya
combinationofflashingwashoperationlights.Themostcommonfailurecodesareshown
below.
TROUBLE CODE POSSIBLE FAULT WHAT TO DO
E01
Thedoorofyourmachineisnotshut
properly.
Shutthedoorproperlyuntilyouhearaclick.If
yourmachinepersiststoindicatefault,turnoff
yourmachine,unplugitandcontactthenearest
authorisedserviceagentimmediately.
E02
The water pressure or the water level
insidethemachinemaybelow.
Checkthetapisfullyturnedon.Mainswater
maybecut-off.Iftheproblemstillcontinues,your
machinewillstopafterawhileautomatically.Unplug
themachine,turnoffyourtapandcontactthe
nearestauthorisedserviceagent.
E03
Thepumpisfaultyorpumpfilteris
cloggedorelectricalconnectionofthe
pumpisfaulty.
Cleanthepumpfilter.Iftheproblempersists,
contactthenearestauthorisedserviceagent.(*)
E04
Yourmachinehasexcessiveamountof
water.
Yourmachinewilldischargewaterbyitself.Once
thewaterhasdrained,turnoffyourmachineand
unplugit.Turnoffthetapandcontactthenearest
authorisedserviceagent.
(*)Seethechapterregardingmaintenanceandcleaningofyourmachine.