How to fix SVAT VU301-C when there is no picture/signal?
First, ensure your TV/monitor is on the correct video input channel (INPUT, AV CHANNEL, LINE 1, LINE 2, or AUX). Refer to your TV or VCR manual for guidance. If the camera is connected to a VCR/DVR, verify it's properly connected to your TV/monitor. Check all connections to ensure they are secure. Lastly, check the camera's power supply to confirm it's powered up.
What to do if the picture on my SVAT Security Camera is too dark?
To address a picture that is too dark on your SVAT Security Camera, especially at night, ensure the subject is within 15ft (this may vary based on ambient light). During the day, adjust the sunshade by sliding it backwards to allow more light. Also, check the brightness and contrast settings on your TV/monitor or VCR/DVR if connected. If needed, relocate the camera.
Why is the picture too bright on my SVAT Security Camera?
To resolve a picture that is too bright on your SVAT Security Camera, make sure the camera isn't aimed at direct sunlight. Adjust the sunshade by sliding it forwards to block excess light. Ensure nothing is obstructing the CDS sensor; if blocked, night vision mode may activate and brighten the picture. You can also try moving the camera to a different location.
General| Lens Type | Fixed |
|---|---|
| Night Vision | Yes |
| Weatherproof | Yes |
| Connectivity | Wired |
| Ingress Protection | IP66 |
| Motion Detection | Yes |
Allows the camera to see in the dark up to 15ft away.
Connecting the camera to the video/power cable.
Supplying power to the camera system.
Connecting the video output to a display device.
Solutions for issues with no video output from the camera.
Troubleshooting steps for non-functional night vision.
To Next Page
