Sven BF-11 - Page 18

Fig. 2. Connection diagram
• Check the Нxation of wires in the connection terminals, polarity and absence of circuit
between the wires and metal parts of the equipment.
• Plug the power cable j into the power cable port i and then into the mains socket. Set the
volume level to its minimum by turning the VOLUME control knob a on the active speaker rear
panel counterclockwise until it stops.
• Shift the POWER switch h into the ON position, and the power LED g will illuminate.
• Turn on the audio source.
• Adjust the volume level by turning the VOLUME control knob a. By turning the knob clockwise,
you increase the volume level, and by turning the knob counterclockwise, you reduce it.
• Adjust the bass and treble levels by turning the TREBLE control knob f and BASS control knob
b respectively. By turning the knobs clockwise, you increase the treble/bass level, by turning the
knobs counterclockwise, you reduce it.
Notes:
• After using the MSS, mind to unplug the power cable j from the mains socket.
• To improve the sound quality, use the Line-Out output of your sound card.
VOLUME
BASS
INPUT
TREBLE
Power
Mini-jack to 2RCA
adapter
2RCA to mini-jack
signal cable
2RCA to mini-jack
signal cable
AUDIO INPUT
SUBWOOFER
Signal cable
Player
DVD
PC
Active speaker
Passive speaker
Power
cable
Audio cable
~220V/50Hz
17
ENG
Operation Manual
BF-11/BF-21/
BF-111