What to do if the Sven Speaker System remote control is not working?
If the remote control for your Sven Speaker System isn't working, the batteries may be discharged. Try replacing them with new ones.
What to do if there is no sound or the sound is too quiet on my Sven Speaker System?
If you're experiencing no sound or very quiet sound from your Sven Speaker System, there are a couple of things to check: * First, make sure the volume level isn't set to the minimum. Adjust the volume control knob to increase the sound. * Second, verify that your audio source is properly connected. Incorrect connections can lead to sound issues, so ensure everything is plugged in correctly.
Why my Sven Speaker System does not turn on?
If your Sven Speaker System doesn't turn on, there are a couple of things to check: * First, ensure that the speaker system is properly connected to a mains outlet. * Second, verify that the power switch is turned on.
How to fix sound distortion on Sven Speaker System?
Sound distortion in your Sven Speaker System is usually caused by a large amplitude of the input signal. To resolve this, turn down the source volume and the MSS volume.
What to do if my Sven MS-304 Speakers have no sound?
If there is no sound or the sound is too quiet, ensure that the volume level is not set to the minimum. Adjust the volume control knob. Also, check that the audio source is properly connected and reconnect it correctly if needed.
Why is my Sven MS-304 Speakers remote control not working?
If the remote control is not working, the batteries may be discharged. Replace the batteries with new ones.
How to fix sound distortion on Sven Speakers?
If you experience sound distortion, the input signal amplitude might be too large. Turn down the source volume and the Sven Speakers volume.
How to fix Sven MS-304 Speakers that don't turn on?
If the Sven Speakers do not turn on, first, ensure that the speakers are connected to a mains outlet. If it's connected, check if the power switch is off and turn it on.
General| Type | 2.1 |
|---|---|
| Signal-to-Noise Ratio | ≥ 75 dB |
| Input Impedance | 10 kOhm |
| Cable Length | 1.5 m |
| Frequency Response | 40Hz - 20kHz |
| Impedance | 4 Ohm |
| Power Supply | ~220 V / 50 Hz |
| Connector | 3.5 mm mini-jack |
To Next Page
