What to do if there is no sound from Sven MS-1085?
If there is no sound from your Sven Speaker System, make sure that the volume isn't set to the minimum. If it is, adjust the volume control knob. Also, verify that the audio source is properly connected and reconnect if necessary.
How to fix a Sven MS-1085 Speaker System that doesn’t turn on?
If your Sven Speaker System doesn’t turn on, check if it is properly connected to the mains outlet. If not, ensure the connection is secure. Also, verify that the power switch is turned on.
Why is the sound of my Sven Speaker System too quiet and distorted?
If the sound from your Sven Speaker System is too quiet or distorted, first, check the volume level and adjust it if it's set too low. Also, if the input signal amplitude is too large, reduce the volume both on the source and the Speaker System itself.
Highlights key capabilities and advantages of the speaker system.
Guidance on optimal positioning of satellites and subwoofer for best sound.
General| Type | 2.1 Speaker System |
|---|---|
| Frequency Response | 40 Hz - 20 kHz |
| Signal-to-Noise Ratio | ≥ 70 dB |
| Configuration | 2.1 |
| Shielded transformer | Yes |
| Bluetooth | Yes |
| FM radio | Yes |
| USB | Yes |
| Card reader | Yes |
| Remote control | Yes |
| Impedance | 4 Ohm |
| Power supply | 220V, 50Hz |
| Subwoofer dimensions | 170 × 220 × 210 mm |
To Next Page
