Why is there no sound coming from my Sven SPS-612 Speakers?
If there's no sound, ensure the volume isn't set too low by adjusting the volume control. Also, verify that your audio source is properly connected.
What to do if my Sven SPS-612 don't turn on?
If your Sven Speakers aren't turning on, first, check if the speakers are properly connected to a mains outlet. If they are, make sure the power switch is turned on.
Why is the sound distorted on my Sven SPS-612 Speakers?
Sound distortion in your Sven Speakers is likely due to a large amplitude of the input signal. Try turning down both the source volume and the speaker volume.
How to fix too quiet sound of Sven SPS-612 Speakers?
If the sound from your Sven Speakers is too quiet, adjust the volume control knob to increase the volume.
General| Frequency Response | 40Hz - 20kHz |
|---|---|
| Power supply | AC 220V, 50Hz |
| Type | 2.1 |
| Impedance | 4 Ohm |
| Speaker drivers | 2 x 2" (Satellite), 1 x 4" (Subwoofer) |
| Driver Unit | 2 x 2" (Satellite), 1 x 4" (Subwoofer) |
| Signal/noise ratio | ≥ 75 dB |
| Signal-to-Noise Ratio | ≥ 75 dB |
To Next Page
