4) Attach the included speaker bracket with the ¼” screw into the brass insert
on the back of the speaker. Make sure the speaker bracket is locked into
position with the lip closest to the terminal. The foam EVA gasket will ensure a
tight fit with the speaker.
5) Connect the speaker wire to your binding posts and hang the Prime Eleva-
tion on the Multi-Angle Wall Bracket (patent pending) as shown. The foam
gasket will make a tight fit and reduce any possible vibration noise.
Note: There will be about ¾” of space between the rear of the speaker and the wall to provide enough space
for both the port and your speaker wire connenction.
The SVS Prime Elevation Speakers include
stick-on bumper kits that can be attached to the
bottom to offer protection when placed on
speaker stands, desktops, shelves and other
surfaces.
MOUNTING WITH THE FOUR-WAY WALL BRACKET
INSTALLING FEET FOR SURFACE PLACEMENT
12
To Next Page
Loading...
