Need help?Do you have a question about the Swann DVR4-1300 and is the answer not in the manual?
General| Video Channels | 4 |
|---|---|
| Storage Capacity | 500GB |
| Compression Format | H.264 |
| Network Connectivity | Ethernet |
| Remote Access | Yes |
| Video Output | HDMI, VGA |
| Network Interface | RJ45 |
| USB Interface | 2 x USB 2.0 |
| Operating System | Embedded Linux |
| Video Input | 4 x BNC |
| Remote Viewing | Yes |
| Motion Detection | Yes |
| Hard Drive Support | 1 SATA HDD |
| Audio Input | 1 x RCA |
| Audio Output | 1 RCA |
| Operating Temperature | 0°C to 40°C |
| Recording Frame Rate | Real-Time 25fps per channel (D1) |
Includes DVR unit, BNC to RCA cable, power adapter cable, and DVR power adapter.
Includes remote control and optional cameras and accessories for setup.
Connect the camera cable's BNC socket and DC socket to the extension cable's plugs.
Connect the other end of the extension cable's BNC plug to the DVR's camera connection.
Connect the DC power sockets from extension cables to the power splitter's DC plugs.
Connect the power splitter's DC socket to the DC plug on the power supply.
Plug the DVR and camera power adapters into power outlets to complete setup.
Connect the RCA end of the RCA to BNC cable to the TV's INPUT socket.
Connect the BNC plug end of the cable to the DVR's VIDEO INPUT socket.
Tune your TV to the correct input, often labelled A/V, input, or source.
