SWELLPRO SPLASH DRONE - Page 39

©2016 SwellPro All Rights Reserved
39
1. Switch on radio controller, long press "Mode" button for 2~3seconds to enter into
[BASIC MENU] interface.
2. Choose the "PARAMETER" item by short press the center location of right switch "Push", then enter
into [PARAMETER] interface.
3. Choose the "STK-MODE" item by sliding the roller switch;
4. Short press the "Push" button to revise the mode from 1.2.3.4 by rotating the roller switch.
5. Conrm the mode "1" by Short press the " Push" button again, then press "End" to nish the setting.
Q10: Can I use the WIFI on my camera when the drone is ying?
A: No, you can’t. Because WIFI works basing on 2.4GHz signal as well, it might interfere the radio signal
in the same frequency that might make the drone out of control.
Q11: Why does the drone start drifting during normal ight?
A: The accelerometer may have been exposed to a sudden/heavy shake; Please execute the
Accelerometer
Calibration to correct it as noted in section 4.3.1.2
Q12: Why is the drone out of control suddenly during normal ight?
A: Probably, the compass suers magnetic interference suddenly. Please switch to ATTI mode to take
over the ight and bring it back close to the take o location, land the aircraft and (stop) lock rotors .
Then attempt to execute the compass calibration as noted in section 4.3.3 assure successful calibration
, and take o once again.
Q13: How long is the charging time for battery?
A: Around 1 hour.
Q14: What’s the root cause of poor satellite under GPS mode?
A: Please make sure there is no overhead shelter from buildings & metal objects, advise to y in open air;
B: Please check whether there is anything sheltering on the top of GPS antenna.