54
10.12.2) X, Y-shaft Timing Belt
1) Completely move the frame fixing plate to the right side to check the X-shaft timing belt tension, and use
the sound wave-based belt tension meter.
2) Strike the center of the belt span with a finger or a similar tool to measure the X-shaft timing belt tension,
and it shall be 10~11kgf when the tension is measured by the sound wave-based belt tension meter.
3) Data input for sound wave-based belt tension meter to adjust the X-shaft timing belt tension
Weight: 003.8gf/m
Wide: 015.0mm/#R
Span: 0707mm
4) When adjusting the X-shaft timing belt tension, loosen the tightening screw for the tension base and turn
the tension adjusting bolt to adjust the tension.
When the bolt is turned clockwise, the belt tension gets stronger. Otherwise, the belt tension gets weaker.
Adjusting Nut
Tightening Screw for Tension Base
Tension
Adjusting Bolt
To Next Page
Loading...
