To Next Page

To Previous Page

PROGRAMMING INSTRUCTIONS

S19002.37_RTS Solar Motors Programming Guide

Technical Support: call 800-544-4749 x3 or email technical.support@swfcontract.com

PAIRING A CONTROLLER TO A MOTOR – LINE VOLTAGE MOTORS

ALL 120V AC RTS MOTORS

1. Unplug motor for two seconds.

2. Plug in motor for 10 seconds.

3. Unplug motor for two seconds.

4. Plug in. Shade will jog or briey move.

5. When the shade stops, press and release the

programming button on the controller and the shade will

jog again.

Note: The shade motor is exclusively paired for control to

this controller/channel.

RESET TO FACTORY MODE – LINE VOLTAGE MOTORS

ALL 120V AC RTS MOTORS

1. Unplug motor for two seconds.

2. Plug in motor for 10 seconds.

3. Unplug motor for two seconds.

4. Plug in. Shade will jog or briey move.

5. When the shade stops, press and hold the

programming button of any controller until the shade

jogs twice.

NOTE: Do not release the programming button until

the jogging is complete or you will have to repeat the

process.

RTS MOTOR

Questions and Answers:

Need help?

Do you have a question about the SWF RTS and is the answer not in the manual?

SWF RTS Specifications

General