18
11) AUTOMATIC TRIMMING DEVICE
The trimming function is automatic, determined by the design and the setup of the machine.
12) AUTOMATIC DETECTION OF UPPER AND LOWER THREAD BREAKS
This device automatically stops the machine when the upper thread breaks, the thread pulls out of the
needle, or the bobbin thread runs out.
13) POWER FAILURE SAFEGUARDS
When the power fails unexpectedly, the frame moves to the exact point where the stitching stopped.
This can help reduce the number of product rejects.
14) 3.5 INCH FLOPPY DRIVE
A 3.5 inch floppy drive is included in the operation panel. Designs can be input by disks and can also be
saved to a disk in Tajima or SWF format. Both 2DD (Double-sided double density) and 2HD (Double-
sided high density) disks can be used.
15) EDITING
You can edit from the control panel. Stitch data and function code (jump, finish, trimming) can be
changed, inserted or deleted.
16) MACHINE STOPPAGE
The screen will indicate why the machine has stopped operating.
17) RPM
The revolutions per minute is indicated on the screen.
18) FRAME SPEED
The speed can be adjusted to high, medium and low.
19) MEMORY
The screen indicates how much memory remains.
20) TAPE CODE COMPATIBILITY
ZSK, and Barudan two binary tape code and Tajima three binary tape code can be edited.
21) CODES FROM OTHER MACHINE BRANDS
Various formats can be automatically edited from the floppy disks. These include SWF, Barudan,
Melco(EXP), Tajima, Happy, Toyota and ZSK.
To Next Page
Loading...
Need help?
General
