Swift Group 2009 Charisma - Truma S 3002 Auto Space Heater

Fitted equipment
60
b. The use of non-Truma spare
parts/accessories
 c. Nonobservanceofthe
operating instructions.
3. The operating pressure for the gas supply is
30mbar(or28mbarbutane/37mbarpropane)
and must correspond to the operating
pressure of the appliance (see name plate).
4. Donotoperatethewaterheaterwhen
refuelling the vehicle and when in the garage.
5. Duringtheinitialoperationofabrandnew
appliance (or after it has not been used for
some time), a certain amount of fumes, and
a slight smell, may be noticed for a short
time.Remedialactionistoimmediately
run the heater at maximum output and to
ensure adequate room ventilation.
6. If the burner makes an unusual noise
or if the flame lifts off, it is likely that the
regulator is faulty and it is essential to have
it checked.
Technical Data
Watercontents: 10litres
Waterpressure: uptomax.2.8bar
Type of gas: Liquid Gas
(propane or butane)
Operating Pressure: 30mbar
(or28mbarbutane,
37mbar propane)
Ratedthermaloutput: 1500W
Gasconsumption: 120g/h
Heating time to approx. 70°C:
Gasoperation:  approx.35mins
Electrical operation: approx. 70 mins
Gas and electrical
operation: approx. 20 mins
Power consumption 12V
Ignition:    0.17A
HeatingUp:   0.08A
Standby:    0.04A
Power consumption 230V
HeatingUp:   (3.7A)850W
Weight (empty): 6.7Kg
TRUMA S 3002
AUTO SPACE HEATER
Instructions for heaters fitted with automatic
ignitor or piezo ignitor
Switching On
1. Openthevalveonthegascylinder.Open
quick-acting valve in gas supply line.
2. Turn control knob to thermostat setting
1-10andpressitdownasfarasthestop.
AtthesametimekeepoperatingthePiezo
ignitor rapidly until the flame ignites.
3. Keep the control knob depressed for a
further10secondstoallowthesafetypilot
to operate.
4. (Piezoonly)Watchthroughtheame
windowforanother10secondstomake
sure that the flame does not go out through
air in the supply pipe (caused by the valve
being closed or changing the cylinder).
Attention: Always wait at least 2 minutes
before attempting to re-ignite, otherwise
there is a risk of blowbacks (misfiring).
This also applies if a working heater goes
out has to be re-lit.
Automatic Ignitor
Prior to first ignition, make sure that the batteries
havebeeninserted;observecorrecttbattery