Equipment Details
MODEL RM4212/4213
STARTING THE REFRIGERATOR
LP Gas operation
After initial installation, servicing, or changing
gas cylinders etc., the gas pipes may contain
some air which should be allowed to escape
by briefly turning on the refrigerator or other
appliances. This will ensure that the flame
lights immediately.
To start gas operation:
1. Open the shut-off valve of the gas bottle
(check that there is enough gas). Open
any on-board shut-off valve.
2. Check that the switches for mains and
12 V operation are off.
If you have model RM 4213 proceed as
follows:
3. Turn on the gas supply by pressing the
(D) knob and turning it to the position
4. Set the thermostat knob (E) to the highest
setting.
5. Depress switch (F). A light in the switch
should now start to flash, indicating that
sparks are being generated at the burner.
6. Press the (D) button. This opens the
flame failure device and allows gas to
flow into the burner.
7. When the flame lights, the sparking stops
automatically and the switch stops
flashing.
8. Keep the (D) button pressed for a further
10 to 15 seconds to activate the flame
failure device, then release it.
If you have Model 4212 proceed as
follows:
3. Turn on the gas supply by pressing the
(D) knob and turning it to the position
4. Set the thermostat knob (E) to the highest
setting.
5. Keeping the flame failure device button
(D) pressed, operate the igniter (G) until
the flame lights.
6. Keep the (D) button pressed for a further
10 to 15 seconds then release it.
The flame can be reserved in a viewing glass
inside the refrigerator at the bottom left (RM
4212).
To terminate the gas operation, turn knob (D)
to and (when applicable) set switch (F) to
“0”.
230 V operation
Turn off gas or 12 V operation when
applicable.
Turn the knob (C) of the thermostat to its
highest (coldest) position.
Set switch (B) to position 1. The switch will
light up green when the power supply is
connected.
12 V operation
Only operate your refrigerator on 12 V when
the engine of the vehicle is running -
otherwise your battery will soon be
discharged.
If applicable, turn off the gas operation.
Set the 12 V rocker switch (A) to 1. The
switch will light up red when the power
supply is connected.
TURNING OFF THE REFRIGERATOR
If the refrigerator is not to be used for some
time:
1. Set any switches to 0.
2. Set the gas valve (D) to
3. Shut off any on-board valve in the gas line
to the refrigerator.
4. Empty the refrigerator. Defrost and clean
it as described earlier. Leave the doors of
the refrigerator and the frozen food
compartment ajar. Use the travel catch to
hold in this position.
51
RM4212
4213
To Next Page
Loading...