30
en
HUMIDITY AND HUMIDIFIER
SAVE SETTINGS
The BONECO U700 saves the last-used settings when
it is switched o. However, if the appliance is dis-
connected from the power supply for a few sec-
onds, it will start in the operating mode.
“AUTO” OPERATING MODE
After switching on, the appliance is in
operat-
ing mode. The desired relative humidity level (rH) is
pre-set to 50% in operating mode. The appli-
ance selects the suitable performance level Low “L”
/ Medium “M” / High “H” to reach the rH value of 50%
as soon as possible.
In
operating mode, the rH can be modified at
any time using the
button. If the performance
level is modified using the button, the op-
erating mode switches o automatically, and the
appliance is in manual operating mode.
The heater can be switched on or o without the
appliance exiting
operating mode. Operating
mode also remains active when setting the
timer.
To return to
operating mode, tap the sym-
bol once.
CONTROLLING HUMIDITY
The humidity can be set between 30% and 70%. In
the “Co” setting (for “Continuous”), the humidi
-
fier runs regardless of the measured humidity. This
means it does not switch o until the tank is empty
or the appliance is switched o.
1. Tap the
symbol. The current humidity indicator
starts flashing.
2. While the indicator is flashing, tap the
symbol
again, until the desired humidity is set.
The value is applied after a few seconds. The indica
-
tor stops flashing.
REGULATE THE OUTPUT
1. Tap the
symbol multiple times, until the de-
sired level appears on the display.
The symbol on the display shows which of the three
levels (low/medium/high) has been selected:
To Next Page
Loading...