34
en
DESCALING
CLEANING FUNCTION
The BONECO U700 is equipped with a descaling
function. All you need is a packet of BONECO A7417
CalcO. One of these packets is included with the
appliance. You can obtain more CalcO bags from
your BONECO specialist dealer or our online store at
www.shop.boneco.com.
The BONECO U700 uses this symbol to indicate that
descaling is needed:
PROCEDURE
During descaling, the water is heated by the heater
for 5 minutes and then pauses for 25 minutes each
time. This process repeats until the cleaning time
has elapsed. The cleaning time can be set between
1 and 4 hours. As a rule: The longer the cleaning pro-
cess, the better the results.
DESCALING THE APPLIANCE
1. Switch o the BONECO U700.
2. Empty the water base and the water tank.
3. Remove the A7017 Ionic Silver Stick® and the
A250.
4. Mix 1 packet of A7417 CalcO with 1 liter (a quar
-
ter gallon) of water and pour the mixture into the
water tank.
5. Place the water tank back onto the base of the
unit.
6. Press the
symbol for 3 seconds. Descaling
starts.
7. Tap the
symbol repeatedly to set the desired
cleaning time. The cleaning time increases by
one-hour increments (max. 4 hours).
The symbol for the cleaning mode flashes on the
display. The BONECO U700 switches o automati
-
cally once the cleaning time has elapsed.
8. Empty the water base and fill the water tank with
tap water.
The cleaning symbol goes out. The BONECO U700 is
ready for use again.
REMOVING LIMESCALE RESIDUE
Stubborn limescale residue on the membrane can
be removed using the yellow brush stored inside
the BONECO U700.
Never clean the membrane using sharp ob-
jects or aggressive cleaning agents; doing so
can damage the BONECO U700 and voids the war-
ranty!
To Next Page
Loading...