8
Removing Hub 2
Note: Avoid grabbing and pulling your Hub 2 directly from the wall, this may cause
damage to it or your wall surface.
Hold your Hub 2, turn it clockwise or counterclockwise and gradually increase force until it
detaches from the wall.
Precautions
Use only 5V 2A power adaptor to connect your Hub 2. Other types of adaptors may
damage or affect normal functioning.
Do not use adaptors that have no safety certifications.
The temperature and humidity sensor is on the cable that we provide. If you use a
normal cable to connect your Hub 2, it will not show temperature and humidity
reading on its display.
Do not outstretch your Hub’s 2 stand with too much force, or the stand may break.
Use only Type-C cable to connect your Hub 2 to a power supply.
Avoid stretching or pulling the cable, this may affect the temperature and humidity
sensor’s data transmission.
To Next Page
Loading...