Operating the Walkie−Talkies
67
Searching for a channel
Signals are searched for on all eight channels and all 38 CTCSS
codes in a continuous cycle. SC appears in the display. The chan-
nel search is stopped if radio communication is found. Press the
P button to enable radio communication.
Starting channel search
and + Start the channel search
Resuming search for a channel
+ Resume the search for a channel
Scanning the CTCSS codes
The CTCSS codes can be scanned after an active channel has
been found.
Scan the CTCSS codes
Stopping channel search
P End the channel search
Dual−channel monitoring
When dual−channel monitoring is activated, the walkie−talkie auto-
matically switches between two channels until a communication si-
gnal is detected. This means you can talk to two callers on separate
channels.
Starting dual−channel monitoring
7 x Activate setting mode
+ or ,, Select the additional channel and
confirm it
+ or ,, P Change the CTCSS code and
confirm it
When dual−channel monitoring is active, the channel cur-
rently set and the additional channel appear alternately in
the display.
Ending dual−channel monitoring
7 x Activate setting mode
+ or ,
OF
, P End dual−channel monitoring
To Next Page
