1
Total Height
Ground Height
Headroom
Drive Through Height
Drive Through Width
Over Guide Width
Note: Due to ongoing development some of the information and procedures may not exactly correlate to the product received. If in
doubt, please ask your supplier.
Electric Roller Garage Door
Installation Instructions
ALWAYS CHECK ON DELIVERY THAT THE ORDER DETAILS ARE CORRECT AND THE
DOOR IS UNDAMAGED BEFORE REMOVING ANY EXISTING DOORS.
Check:
i) delivery note
ii) order sheet
iii) door dimensions/colour
iv) opening dimensions \clearances
v) components
vi) Check for any damage to the guide rails
or the outside roll of the curtain
Do not proceed further with the
installation unless you are sure that
the door is the correct size, and all
components are present.
Widths
Order Width = Over Guide Width
Drive Through Width = Over Guide Width less 150mm for 75mm guides
Drive Through Width = Over Guide Width less 180mm for 90mm guides
Curtain Width = Over Guide Width less 90mm
Axle Width = Over Guide Width less 90mm (without spring)
= Over Guide Width less 73mm (with spring)
Heights
Order Height = Guide Height
Total Height = Guide Height + End Plate
Headroom/End Plate
up to 2.5m Guide Height = 300mm
up to 3.5m Guide Height = 350mm
Drive Through Height = Guide Height less 55mm
1
April 2013 Issue 1 MK516BO
Sequence of Installation & Contents
1. Pre-installation and component check
2. Installation options and criteria for compliance with LPS 1175
3. Prepare the opening
4. Prepare the guide rails
5. Fit end plates, guides & axle (& optional fascia)
6. Fit emergency overrides
7. Curtain adjustment (reducing height/making repairs)
8.
Install the curtain in the guides, attach to axle & fit stops
9. Curtain locking & setting motor limit switches
10.
Commissioning
11. Maintenance, repairing and dismantling instructions
1. PRE-INSTALLATION AND COMPONENT CHECK:
To Next Page
Need help?
General
