INTERNAL FITTING
Fit optional 45 degree lid. A slot may have to be cut into the lid to
pass over the override eye.
FINAL CHECKS
i) remove any protective plastic coverings
ii) wipe curtain & guides with damp cloth
iii) touch-up any small scratches
iv) check all electrical & operating equipment is installed and
functioning correctly (especially the safety edge) and complete
CE marking label and paperwork
v) check direction handle needs winding to open door and fit
appropriate label supplied to crank handle.
vi) If the door is fitted externally apply a bead of silicone around
the box edge to prevent water ingress.
N.B. Check the front of the curtain to make sure that it is not
rubbing on the fascia etc.
The manual override will not function after the door is operated,
by remote control, until the power to the motor has ‘timed out’.
This will take a few moments to occur.
If you wish to demonstrate the manual override immediately after
opening the door press either the stop button on the handset or
simulate a power cut by switching off the power to the Control
unit.
If a low level external override is fitted or the door is fitted
externally remind customers to keep the override handle in a
convenient place (not in the garage if no other way in!)
Upon completion it is your responsibility to train
the customer how to operate the door correctly
and safely and provide them with the operating
and maintenance instructions supplied.
10. COMMISSIONING
11. MAINTENANCE, REPAIRING AND DISMANTLING INSTRUCTIONS
Always isolate the mains power before attempting any
maintenance, repairs or dismantling.
MAINTENANCE CHECK LIST
i) Curtain free running and clean
ii) No debris in the guide rails
iii) Guide rails and end plates are securely fastened to the wall
(check also the fascia if fitted)
iv) All axle collars are in the correct original position
v) Split pin in octagonal dummy end fixing plate is in correct
position and is not damaged or worn
vi) Check the action of the locking mechanism to ensure it is
locking correctly.
vii) Motor cable is correctly retained has not been damaged or in
danger of being damaged
viii) If a remote control has been supplied check the functionality
of the safety devices
ix) Check the operation of the manual override.
RECOMMENDED SERVICE PERIOD
The recommended service period for a garage door, which will
operate on average two cycles per day, is once every 12 months.
If the garage door will perform a greater number of cycles per day
the service period should be shortened accordingly. One cycle is a
full open and close sequence.
REPAIRS
For curtain repairs please refer to section 6.
9 9
To Next Page
Loading...
