2.3 MENU for SPEED LIMIT
MENU for SPEED LIMIT
1. To set up speed limit
• Turn off display
• Press and hold thumb brake
• Power the display
• The display will show “L1”
2. Move to menu with button [LIGHT] L1-L2-L3-L4-L5
• To set up a new speed limit, press button[SET]
MENU for FUNCTION
1. To set up one of this program:
• Turn on display
• Press and hold thumb brake
• Press the button [POWER]
• The display will show:P1
2. Move to menu with button [LIGHT] P1-P2-P3
• To set up a new value, press button [SET]
• To finish the settings, release thumb brake
ERROR CODE
E1: Overcurrent protection (Motor does not move
more than 4 seconds)- this error clears after
release the acceleration throttle. If not clear,
send to service.
E2: Communication error (No communication for
more than 400ms) - this error clear when
starting the communication. If not clear, send
to service.
E3: Overvoltage error (Battery voltage higher).
Put back original battery, other hardware
problem.
• Black-Screen. Exposure under the sun for too long.
Place it in shadow and it will return to normal after a
period of time. If not clear, send to service.
L1= Limit the speed to 6km/h
L2= Limit the speed to 12km/h
L3= Limit the speed to 20km/h
L4= Limit the speed to 25km/h
L5= Limit the speed to 30km/h
p1 = zero Start [ON/OFF]
p2 = Cruise Control [ON/OFF]
p3 = Regenerative Brake [ON/OFF]
To Next Page
Loading...
Need help?
General
