Sylvac S Dial WORK NANO Smart - Instrument Customization and Connectivity

21
E
14. Personalising the instrument
Access to the functions of your instrument can be personalised, for more information see manufacturer’s website (requires
you to connect your instrument via a Proximity or Power RS / USB cable).
Possibilities:
- Enable or disable the required functions
- Modify access to the Second level functions (direct access)
15. Connecting the instrument
The instrument can be connected to a peripheral via a Proximity (RS or USB), Power (RS or USB) cable, or Bluetooth
®
.
See page 2 for connecting the Power cable.
Measured values can be transmitted and the instrument driven using predened retro-commands (see chap. 16 for a list
of the main commands)
Note :
In Tolerance mode, the tolerance limit lights remain lit only for a few seconds while the measurement stabilises. On the
other hand, they will remain lit continuously if the instrument is connected to, and powered by, the Power RS (USB) cable.