7
• Odometer：
This odometer shows the total kilometers this scooter has been driven.
Total kilometer : This shows the total kilometers of this scooter. It shows six digits; 5 in kilometers and 1
in hundred meter. (The total kilometer will return to zero if it runs over 100000 kilometers.)
Trip kilometer : The rider can measure the trip kilometers. It shows four digits; 3 in kilometers and 1 in
hundred meter. (The trip kilometer will return to zero if its measurement is over 1000 kilometers.)
• Water temperature gauge
To indicate engine coolant temperature.
When the main switch turns to “ON”, the LCD and the water temperature indicator keeps coming on.
Normally, the LCD indicator should be below the (H) position when the motorcycle is operating. If the
LCD indicator stays above (H) position, the water temperature indicator flashes. Please check the
coolant level of spare coolant tank and check cooling fan for proper operation.
• Time setting
Set time in 24 hour mode.
When the main switch turns to “ON” the clock shows hours and minutes in 24 hour mode.
At this “Time mode” press HOUR and MIN bottom at the same time, and enter the “Time setting mode”.
At this moment the time digit flashes: press the HOUR bottom once and the hour increases. Keeping on
pressing for 2 seconds can accelerate the adjustment. (The minute adjustment by MIN bottom is the
same like this.)
At “Time setting mode” press HOUR bottom and this bottom will not flash for 2 seconds. (The same as
MIN bottom.)
When time setting completed. Press ALARM bottom or without pressing HOUR or min bottom for 3
seconds to exit “Time setting mode”.
• Time setting
Set alarm time.
When the main switch turns to “ON” the clock shows hours and minutes in 24 hour mode. At this “Time
mode” press ALARM bottom and enter “Alarm mode”. The “ALARM” sign on the meter comes on at the
same time.
At this “Alarm mode” press HOUR and MIN bottom at the same time and enter “Alarm time setting mode”.
At this moment, time and “ALARM” sign is flashing
at this moment, time and “ALARM” sign is flashing; press HOUR bottom once and the hour increases.
Keeping on pressing for 2 seconds can accelerate the adjustment.(The minute adjustment by MIN
bottom is the same like this.)
At “Alarm setting time mode”, press HOUR bottom and this bottom will not flash for 2 seconds.( The
same as MIN bottom.)
When alarm time setting completed, press ALARM bottom or without pressing HOUR or MIN bottom for
3 seconds to exit “Alarm time setting mode” and enter “ Alarm mode”, the ALARM sign on the meter
keeps coming on; when the set time is up, the time and ALARM sign will keep on flashing, then gone
after 3 minutes.( The ALARM sign is gone, and the time will not flash.)
When the alarm time has been set, press ALARM bottom to erase the alarm and enter “Time mode”.
CAUTION:
The indicator will stay above (H) position when engine is run under high temperature for a long period
of time. In this case, the only way to cool the engine is to stop the engine.
To Next Page
Loading...
Need help?
General
