10
3.1 Remote control and boat model pairing
1. Turn on the power switch of the remote control, the power indicator will flash, then put the boat model
into the water. If the power indicator is always on, it means the remote control and the boat model are
successful in pairing.
2. If the remote control and the boat model are not successfully paired, the power light will flash.
3.2 Function operation
to go forward
6. Press down on the spindle rubber part and fit the propeller, then fit the set screw with a
wrench.
3.0 Remote Control Guide
EN
Notice
!
1. The battery cables should be lined up to the side of the boat so that the inner hatch cover is tight.
2. All plugs should be plugged in tightly.
3. Make sure the hatch is tightly covered to prevent leaks.
To Next Page
Loading...