KEYBOARD CONFIGURATION, IF YOU SEND THIS SEQUENCE AT LINE 3 OR MORE :
><K0 = Barcode set to OFF
><K1 = Barcode set to ON
><K2 = Keyboard set to OFF
><K3 = Keyboard set to ON
><K4 = Keyboard and Barcode set to OFF
><K5 = Keyboard and Barcode set to ON
><K6 = Keyboard mapping for UNIX
><K7 = Keyboard mapping for AS/400
><K8 = Keyboard AS/400 M5 = F5
><K9 = Keyboard M5 = TAB
><KH = Keyboard AS/400 ESC = F12
* In mode Keyboard and/or Barcode OFF, the Light LED of your terminal is locked to ON
GENERAL CONFIGURATION, IF YOU SEND THIS SEQUENCE AT LINE 3 OR MORE :
><KT = Disable Time and Date display
><KJ = Half Duplex mode
(Default)
><KK = Full Duplex mode
><KL = CapsLock ON
(Default)
><KM = CapsLock OFF
><KN = Change cursor position: Line 2 Column 1
><KZ = ESC
><KPx = Pause x, 1 = .5 secondes (possible values 1 to 9, A to Z, a to z)
><KWx=Watch dog configuration 0 = OFF, 1 = ON
GENERAL CONFIGURATION, IF YOU SEND THIS SEQUENCE AT ANY POSITION:
><KI = Clear Screen
KEYBOARD DEFINES, IF YOU SEND THIS SEQUENCE AT LINE 3 OR MORE (Ver. 1.4L or more):
><KAx = Key M1 = character x
><KBx = Key M2 = character x
><KCx = Key M3 = character x
><KDx = Key M4 = character x
><KEx = Key M5 = character x
><KFx = Key ESC = character x
><KGx = Key ENTER = character x
If x = . then Key = Default value
If x = - then Key = Tab
To Next Page
Loading...