TTL IN Enable / Desable / Request Status, , IF YOU SEND THIS SEQUENCE AT LINE 3 OR MORE :
><TxIy
x = TTL Number 1 or 2
y = Sets the terminal TTL IN x
to 0-DESABLE, 1-ENABLE 2-Request Status (Default = Disable)
Sequence example, set TTL input 2 set to Enable: ><T2I1
TTL IN RETURN:
&xy
x = TTL Number 1 or 2
y = Status 0 or 1
Sequence example, TTL input 2 change: &21
LIGHT LED AND EMIT SOUND, IF YOU SEND THIS SEQUENCE AT LINE 3 OR MORE :
><H = Light LED
><I = Emit SOUND
><J = Light LED and Emit SOUND
><L0 = Barcode BIP validation OFF
><L1 = Barcode BIP validation ON
SET CURRENT DATE AND TIME, IF YOU SEND THIS SEQUENCE AT LINE 3 OR MORE :
><EHHMMSSE = SET THE CURRENT TIME
><DMMDDYYD = SET THE CURRENT DATE
SHOW TIME, THE TERMINAL REPLACES THIS CHARACTER BY THE CURRENT TIME:
CHR(240) or > = Show and refresh time.
SHOW DATE, THE TERMINAL REPLACES THIS CHARACTER BY THE CURRENT DATE:
CHR(241) or < = Show and refresh date.
CHANGE CURSOR POSITION:
Chr(27) + "[" + POS_Y + ";" + POS_X + "H"
CLEAR SCREEN:
Chr(27) + "[2J"
To Next Page
Loading...