DOC 6511_Release K
ATS-6511A/B/C Users Guide
11
2.4.2.5 4387A (Modulated IRIG/NASA36)
This module provides four Amplitude Modulated (AM) IRIG Outputs or the NASA36 Serial
Time Code. Valid AM IRIG Codes are A(130, 133, 137), B(120, 123, 127), E(111, 112, 121),
G(141, 142, 147), and H(111, 112, 121, 122, 127). Default is B120.
• IRIG: To set the IRIG Code for the individual ports use the irig command:
ATS-6511> irig [slot#] [port#] [Code A-H] [Code Format <NNN>] [epoch]
The following example sets the IRIG Code for Slot 5, Port 3 to G 141.
ATS-6511>irig 5 3 G 141 0
[OK] 2013-08-13T14:31:11Z
The system will generate an error message if the operator attempts to enter an
unsupported or invalid code.
To verify the settings use the settings hardware:slots:N command (N=Slot #) to obtain
the current settings for a particular card.
ATS-6511> settings hardware:slots:5
[tsc4387]
[ports]
[1]
[epoch_127] false
[format] B
[signal_word] 120
[type] irig
[2]
[epoch_127] false
[format] B
[signal_word] 120
[type] irig
[3]
[epoch_127] false
[format] G
[signal_word] 141
[type] irig
[4]
[epoch_127] false
[format] B
[signal_word] 120
[type] irig
[OK] 2013-08-13T14:32:28Z
• NASA36: To set the NASA 36 Code for the individual ports use the nasa36
command:
ATS-6511> nasa36 [slot#] [port#]
The following example sets the Time Code for Slot 5, Port 3 to NASA 36.
ATS-6511>nasa36 5 3
To Next Page
Loading...
Need help?
General
