DOC 6511_Release K
ATS-6511A/B/C Users Guide
30
Command Description
Basic Commands
help, h or ?
<command>
Display help for a command or list all commands. Proper format is to
proceed the command with help, h, or ? help <command>
quit Closes the command connection and terminates the telnet connection.
Status
Commands
show Shows the current system factory (config), user configuration (settings),
network (network), and system status (status) values. This command is
the equivalent of sending these 4 commands at the same time.
status Shows the values of all runtime status variables
alarm Shows the current alarm state
alarms Shows active alarms
config Shows unit configuration parameters
network Show network interface configuration. Note: These settings do not apply
if the mode=DHCP.
syslog Dump the system log file.
diag Adjust diagnostic logging levels.
diag_port Switch to the diagnostic port (1800).
ptdavg_port Switches the command port display to port 2100 to view the average
measurement results.
ptdraw_port Switches the command port display to port 2101 to view the raw
measurements every second.
status_port Switch to the status port (1900)
Settings
settings Shows the current user control/configuration settings.
diff Displays any difference between the current system settings and the saved
user configuration file.
load Restore system configuration settings from a file on the disk
save Save current configuration settings to disk. save <filename>. Default =
<default>
list List available user configuration files available on disk. If there are no
files listed the ATS-6501 is using the factory default settings.
delete Deletes specified user system configuration files.
Fiber
Commands
fiber_delay Set fiber delay for each fiber input channel
fiber_delay_diff Delay path difference for each fiber input channel
fiber_mode Set the proper fiber operating mode
fiber_switching Set the proper fiber switching policy for the unit.
dist_delay Set the distribution delay for the 1PPS Outputs.
Reference
Commands
reference Indicates which frequency reference to use (internal | external)
reference_type Indicates which frequency reference is providing the external reference
input (cesium|hp5071a)
To Next Page
Loading...
Need help?
General
