DOC 6511_Release K
ATS-6511A/B/C Users Guide
36
C. There should be no active alarms on the system.
ATS-6511>status
[alarm] no alarm
D. Check the fiber status:
[fiber]
[chassis_delay] -7.000000000000000e-10
[clock_offset] 1.000000001666679e-10
[da4340delay] 0.000000000000000e+00
[fpga]
[delay] 0.000000000000000e+00
[inputA] good
[inputB] good
[steer] -1.000000000100000e-12
[two_way]
[channelA]
[4340_output] 0
[clock_offset] 1.000000001666679e-10
[direct_connect] true
[fiber_delay]
[local] 6.876666666716667e-08
[remote] 6.313333333333334e-08
[remote_tdc_time] 2011-11-07-17:22:23
[rxdelay] -3.690000000000000e-08
[txdelay] -3.690000000000000e-08
[channelB]
[4340_output] 0
[clock_offset] -6.920892494745100e-09
[direct_connect] true
[fiber_delay]
[local] 5.302163624125489e-08
[remote] 7.476470588235293e-08
[remote_tdc_time] 2011-11-07-17:22:25
[rxdelay] -3.650000000000000e-08
[txdelay] -3.650000000000000e-08
E. Both fans should be operating properly.
[hardware]
[fan]
[1] true
[2] true
F. Verify the system hardware is operating properly by ensuring the system is displaying the
proper serial number, the outputs are enabled, and the power supply status is good. The
slots fields should show which cards are installed in each slot (or empty if no card is
present), the port status for all four outputs are good and power is enabled. The system
temperature should be below 50ºC.
[mainboard]
[EUID] 00:a0:69:00:03:00:00:f8
[serialnum] 164233
[type] 6511
[outputs]
[enabled] true
To Next Page
Loading...
Need help?
General
