DOC 6511_Release K
ATS-6511A/B/C Users Guide
84
Diag_port:
Description: Switch to diagnostic port. Changes the current command port (1700)
connection into a diagnostic port (1800) connection. Hitting the <return> key will switch
the connection back into a command port connection
Syntax: diag_port
Command Example:
ATS-6511>diag_port
Note: Hit <return> key to switch back to command port
Diff:
Description: Shows unsaved changes to the user/system settings. Show the differences
between the current settings and the last saved settings. If the application is restarted or
rebooted by the user the system will revert to the previously saved settings.
Syntax: diff [--view <tree | flat>] [--nodesonly]
--view Specify the output view. Default is tree.
--nodesonly Output only the names of changed nodes.
i.e., don't display values
Command Example:
ATS-6511B>diff (same as diff --view tree)
[current]
[fiber]
[mode] two_way_disabled
[ptd_port]
[averaging_interval] 20
[original]
[fiber]
[mode] two_way
[ptd_port]
[averaging_interval] 10
[OK] 2011-06-10T16:58:47Z
ATS-6511B>diff --view flat
ATS-6511B>diff --view flat
current:fiber:mode=two_way_disabled
current:ptd_port:averaging_interval=20
original:fiber:mode=two_way
original:ptd_port:averaging_interval=10
[OK] 2011-06-10T17:00:25Z
ATS-6511B>
ATS-6511B>diff –nodesonly (Shows only the changed value, not the original setting)
[fiber]
[mode] two_way_disabled
[ptd_port]
[averaging_interval] 20
To Next Page
Loading...
Need help?
General
