DOC 6511_Release K
ATS-6511A/B/C Users Guide
91
The load command will only change those settings that are found in the specified file. If
the file contains only a subset of the settings tree than only those settings will be affected.
Also, if a user wishes to only load a subset of the settings within the file they can specify
the specific node within the file that should be loaded. For instance, load default fiber will
load only fiber settings.
See Also: save, list, show, settings
Syntax: load [filename]
Command Example:
ATS-6511>load test
Query:
ATS-6511>list
default
test
Maintenance_mode
Description: Enable maintenance mode. Allows operators to put all of the down stream
6511s on the same fiber while performing maintenance on part of the system that may force
units to be on different clock sources.
Usage: maintenance_mode <on|off>
Nasa36:
Description: Select nasa36 output type. The 4387A output module enables the user to
independently configure an output port to generate a variety of signal formats and
timecodes. By default, the 4387A output modules will produce the following signals until
reconfigured by the user:
4387A
Port 1: IRIGB-120
Port 2: IRIGB-120
Port 3: IRIGB-120
Port 4: IRIGB-120
In order to configure a specific output port the port address must be given. To identify the
port address use the slot number and port number of the desired port.
Slot Numbering when looking at the rear panel:
[Slot 1] [Slot 3] [Slot 5]
[Slot 2] [Slot 4] [Slot 6]
Port Numbering when looking at the 4387A or 4394A outputs:
[1] [2] [3] [4]
To Next Page
Loading...
Need help?
General
