Why is my Symmons SCOT SLC-6000 Kitchen & Bath Fixtures faucet dripping?
If your Symmons Kitchen & Bath Fixtures faucet drips, it could be due to a worn seat washer or foreign matter between the washer and the seat surface. To resolve this, disassemble the cartridge, remove the piston, remove the screw, and clean the seat washer. Also, check the control rod pin for burrs before reassembling.
How to fix a loose handle on Symmons SCOT SLC-6000?
If the handle on your Symmons Kitchen & Bath Fixtures is loose, it's likely that the set screw has loosened. Simply tighten the set screw to secure the handle.
What to do if Symmons SCOT SLC-6000 faucet runs constantly?
If your Symmons Kitchen & Bath Fixtures faucet runs constantly, it could be due to the seat washer not closing properly or wear on the seat washer and/or seat surface. Remove the piston and spring, and check the pin for burrs. Inspect the spring for damage. You may need to replace both the piston and the spring. Excessive wear might require replacing the entire cartridge.
How to stop water leaking from under the handle of Symmons SCOT SLC-6000 Kitchen & Bath Fixtures?
If water leaks from under the handle of your Symmons Kitchen & Bath Fixtures, it's likely that the stem washers are worn. Remove the cartridge and replace the housing o-rings. If the leak continues, replace the control spindle kit.
How to fix a Symmons SCOT SLC-6000 Kitchen & Bath Fixtures faucet that leaks on or under the counter?
If your Symmons Kitchen & Bath Fixtures faucet leaks on or under the counter, the supply housing o-rings are likely worn. Replace the housing o-rings to resolve this issue.
Why is the handle sticking to the cartridge on my Symmons SCOT SLC-6000 Kitchen & Bath Fixtures?
If the handle is sticking to the cartridge on your Symmons Kitchen & Bath Fixtures, it's likely due to sediment accumulation in the cartridge. Remove the handle and all cycle timing washers from the cartridge. Secure the handle back onto the cartridge. Move the handle to the hot position, then cycle the faucet by pressing down on the handle 12 times. Remove the handle and replace the timing washers.
How to adjust the run time on a Symmons SCOT SLC-6000 faucet?
If your Symmons Kitchen & Bath Fixtures faucet runs too long or too short, the cycle timing washers may not have been adjusted properly. Remove the handle, then add cycle timing washers to the stem to shorten the time or remove washers to lengthen the time.
How to clean spotting on Symmons SCOT SLC-6000 Kitchen & Bath Fixtures finish?
If the finish of your Symmons Kitchen & Bath Fixtures is spotting, elements in the water supply may be causing water staining. Clean the finished trim area with a soft cloth using mild soap and water or a non-abrasive cleaner, and then quickly rinse with water.
Lists individual faucet parts with their part numbers for easy ordering and replacement.
Connects supply stops, faucet, mounting hardware, and copper tubing.
How to adjust the faucet's cycle time by adding or removing timing washers.
How to remove, inspect, and replace the faucet cartridge.
Lists problems like dripping, leaks, and sticking handles with causes and solutions.
General| Brand | Symmons |
|---|---|
| Model | SCOT SLC-6000 Series |
| Category | Kitchen & Bath Fixtures |
| Language | English |
To Next Page
