Synaccess netBooter PDU Series - Networking and System CLI Commands

Networking and System Configuration/Operations
CLI Command
Description
nwshow
Displays network settings and status, including IP address, gateway, MAC
address, and more
nwset
Resets the network interface
dhcp <x>
Sets IP to DHCP mode (x=1) or Static mode (x=0)
ip <ip> <mask>
Sets the static IP address of the device to <ip> and the mask to <mask>
Please note that this IP setting is only applicable if DHCP mode is disabled (e.g.
device is in static IP mode). In other words, if DHCP mode is enabled, this IP
setting is not active/relevant until static mode is enabled.
gw <gw>
Sets gateway IP to <gw> for static IP mode
Please note that this IP setting is only applicable if DHCP mode is disabled (e.g.
device is in static IP mode). In other words, if DHCP mode is enabled, this IP
setting is not active/relevant until static mode is enabled.
mac
Displays the Ethernet Port Mac Address
web <v>
Enables or disables web access.
“1” = Web access On
“0” = Web access Off
mask <m>
Sets the mask of the device to <mask>
emailsend
Sends a test mail to the configured email(s)
hp <port>
Sets the HTTP port to <port>
tp <port>
Sets the Telnet port to <port>
help
Help menu
Ipsrc <ip>
Sets filtered source IP to <ip>, and only allows said ip to access unit
login
Logs into the unit
logout
Logs out of the unit
sysshow
Shows system information
ver
Shows version of firmware