screw hole
Screw
Please tighten the screw.
If not tightened, the remote control stand may
fall off, causing failure or injury.
If the remote control stand is forcibly moved when the
screw is tightened and fixed, this may cause an
excessive load on the movable part and its fracture.
Please pay attention to it.
Align the remote control stand with the screw
holes on the main body and fix it with screws.
Back pad
Convex part of the
main body（②）
Concave part of remote
control stand（①）
Shoulder air bag
Align the concave part (①) of the remote
control stand with the convex part (②)
of the main body and insert it between
the cloth layers.
Installation of remote control stand
※can only be installed on the right side.
The convex part of the main body is
covered with cloth and is not visible.
Please refer to the position in the right
figure for insertion.
13
To Next Page
Loading...
