DECLARATION OF CONFORMITY FOR
LOAD CELL AMPLIFIERS
Name of manufacturer or supplier: Synectic Design Ltd
Registered office: 48 Brindley Close
(including country of origin) Farnworth
Bolton
Lancashire
England
Postcode: BL4 0AG
Description of product: SY038 Analogue Load Cell Amplifiers
including all variants
Standards under which conformity is declared:
BS EN 61326-1: 2006 Electrical equipment for measurement, control and
laboratory use-EMC requirements. Part1-2-3
BS EN 61000-4-2:1995, Immunity to electrostatic discharge
1ec 61000-4-2:1995 Tested up and including level 8KV Air discharge
BS EN 61000-4-3:2006 +A1:2008 Immunity to radiated frequency electromagnetic fields
at 10V/M
BS EN 61000-4-4:2004 Immunity to electrical fast transient/burst. Test levels
Up to and including +/-4KV on supply ports and +/-2KV on
input/output signal and data ports. (test Level 4)
Directive 2011/65/EU In relation to restriction of use of certain hazardous
(RoHS2) substances in electrical and electronic equipment.
REACH (article 3) Synectic Electronics Ltd are manufacturers of electronic
hardware. We are seen as a ‘down stream user’ according to REACH regulations. We are
therefore are not required to register with the European Agency for chemicals ‘ECHA’.
Name of authorised representative: Brian Peter Tonge
Position of authorised representative: Technical Director
Declaration
I declare that, as the authorised representative, the above information in relation to the
supply/manufacture of these products, when used as recommended, are in conformity with the
stated standards and other related documents following the provision of EEC Directives.
Signature of authorised representative:
Date: 15/09/2015
Revision 17-10-2017
To Previous Page
Loading...