default prompt of the second language in a multilingual set up, first set the
Language number in Program# 120 to 2 and then use the program
numbers 701 to 724 to change the desired default prompt.
To record all Default prompts one after the other, use Program number 700
followed by the Language number 1 or 2. Start recording after you hear a
long beep. A silence of 3 seconds, the # tone and 0.6 sec of silence must be
used to separate two consecutive messages. This program is useful in
recording the second language prompts for the first time.
Program # 800, 801- 824 Listen to Default prompts and greetings
Program number 800 plays back all the Default prompts one after the
other. Use program number 801 to 824 to listen to any one prompt at a
time.
To listen to the default prompt of the second language in a multilingual set
up, first set the Language number in Program# 120 to 2 and then use the
program numbers 801 to 824 to listen to the desired default prompt.
Program # 900, 901-924 Record All prompts and greetings (through PC,
local)
All the default prompts may be recorded by playing a voice file on the PC
and fed into the unit through the Music / Audio input of the ATT 2000 unit.
Under this program, the unit goes on-hook after the program number is
entered.
To change the default prompt of the second language in a multilingual set
up, first set the Language number in Program# 120 to 2 and then use the
program numbers 901 to 924 to change the desired default prompt. To
record all Default prompts one after the other, use Program number 900
followed by the Language number 1 or 2.
The unit gives a long beep and goes on hook after the digit specifying the
Language number is entered. Start recording after the unit goes On-Hook.
A silence of 3 seconds, the # tone and 0.6 sec of silence must be used to
separate two consecutive messages. This program is useful in recording the
second language prompts for the first time.
Note:
The difference between Program numbers 700-724 and 900-924 is that in
700-724, the unit remains Off-hook and the prompts must be fed through
the telephone line either by speaking into the phone directly or by using
the special PC-to-phone adaptor when the prompt file is played on the PC
and the ATT 2000 unit is in a remote location.
52
To Next Page
Loading...