Synology DiskStation DS2419+ - Page 12

12
Chapter 2: Hardware Setup
To make sure DiskStation recognizes the new memory capacity:
1
Install DiskStation Manager (DSM). (See the next chapter for more information.)
2
Log in to DSM as
admin
or a user belonging to the
administrators
group.
3
Check
Total Physical Memory
in
Control Panel
>
Info Center
.
If your DiskStation fails to either recognize the memory or start up successfully, conrm that the memory has
been properly installed.
To remove the RAM Module:
1
Follow step 1 to 3 of the "To install the RAM module" section to shut down your DiskStation, disconnect the
cables, and then remove the bottom lid.
2
Push the levers on both sides of the memory module outwards. The module will be released from the slot.
3
Hold the memory module by its notches and remove it from the slot.
4
Replace the side panel. Replace and tighten the screws you removed in the initial step.