Need help?Do you have a question about the Synthes LCP Distal Humerus Plates and is the answer not in the manual?
General| Brand | Synthes |
|---|---|
| Model | LCP Distal Humerus Plates |
| Category | Medical Equipment |
| Language | English |
Lists types of distal humerus fractures suitable for the implant.
Lists conditions or patient groups where the implant should not be used.
Lists dorsolateral and medial plates for distal humerus fixation.
Details LCP locking screws with various sizes and features.
Details standard cortex screws with various sizes and features.
Provides templates for identifying plates via X-ray.
Details torque limiters for LCP locking screws.
Lists drill sleeves and bits for LCP locking screws.
Details depth gauges for measuring screw length.
Describes patient positioning and the posterior surgical incision.
Covers fracture reduction, temporary fixation, and dorsolateral plate selection.
Details determining plate length and preparing plates by bending.
Describes positioning the dorsolateral plate on the distal humerus.
Details preliminary fixation of the plate using drill guides.
Instructions for inserting the self-tapping cortex screw.
Process for pre-drilling the distal hole with a drill bit.
How to determine screw length using drill guides and depth gauges.
Details inserting LCP 2.7 mm distal screws.
Describes positioning and adapting the medial plate to the bone.
Details preliminary fixation of the medial plate to the bone.
Instructions for fixing the distal part of the medial plate.
Instructions for attaching the LCP drill sleeve to the plate.
Process for pre-drilling screw holes in the bone shaft.
Details inserting LCP locking screws into the shaft.
Describes positioning the dorsolateral plate without support.
Details preliminary fixation of the plate to the bone.
Instructions for fixing the distal part of the plate.
Describes fixing the aiming block to the plate.
Describes positioning the dorsolateral plate using the PCD.
Instructions for fixing the plate with a cortex screw.
How to use the PCD to determine screw length.
Details inserting the LCP 2.7 mm screw using the PCD.
Instructions for inserting additional LCP or cortex screws.
To Next Page