Master Language is English Hot Runner System Installation Guide SVC-17-0001_EN-Rev11
RESTRICTED: Property of Synventive. - 392 - All rights reserved. Errors and omissions excepted
For limited third party distribution based on need and intended use. © 2019 Synventive Molding Solutions
H O T R U N N E R T E C H N O L O G Y
Hot Runner System Installation Guide
Service and Maintenance / Single Axis Valve Gate Nozzle 16SVH
7) Keep the suspension ring showen like the right side gure
(Doc007377.png).
Doc007377.png
NOTICE
If the suspension ring is not exactly aligned with the
large recess to the cooling strip, place the bearing ring
(HYC2314SR01) in the shortest path to the position shown in
figure Doc007377.png.
Doc007372.png
NOTICE
Examine whether the isolation ring (2) at the nozzle head top
(3) is placed in the right position.
8) Mount the actuator (8) at the nozzle.
Doc007290.png
To Next Page
Loading...