Master Language is English Hot Runner System Installation Guide SVC-17-0001_EN-Rev11
RESTRICTED: Property of Synventive. - 401 - All rights reserved. Errors and omissions excepted
For limited third party distribution based on need and intended use. © 2019 Synventive Molding Solutions
H O T R U N N E R T E C H N O L O G Y
Hot Runner System Installation Guide
Service and Maintenance / Single Axis Valve Gate Nozzle 16SVH
10.3.2.7 Valve Pin Height Adjustment
1) Unscrew the socket set screw (19).
2) Close the valve guide by pressure on the hydraulic connection (A).
3) Adjust valve pin position with a suitable pin in holes of the adjustment bushing (HYC2314AB01).
4) Turn the adjustment bushing (HYC2314AB01) by using a pin to get the valve pin front into basic position 0,3 mm.
NOTICE
Turning one hole forward results in a height adjustment of 0,25 mm at the valve pin.
5) Tighten the socket set screw (19).
Doc007366.png
(A) Hydraulic access “CLOSE”
(B) Hydraulic access “OPEN”
To Next Page
Loading...