Master Language is English Hot Runner System Installation Guide SVC-17-0001_EN-Rev11
RESTRICTED: Property of Synventive. - 386 - All rights reserved. Errors and omissions excepted
For limited third party distribution based on need and intended use. © 2019 Synventive Molding Solutions
H O T R U N N E R T E C H N O L O G Y
Hot Runner System Installation Guide
Service and Maintenance / Single Axis Valve Gate Nozzle 16SVH
Doc007285.png
7) Remove the isolation nut (1).
8) Lift the complete actuator housing (8)
from the guide sleeve (9).
9) Unscrew the suspension ring (HYC2314SR01).
Doc007375.png
10) Loosen and remove the socket cap screws (10, Part of HYC2314S01)
and (11, Part of HYC2314S01).
11) Remove the protection ring (07, Part of HYC2314S01) from the cylinder
housing (01, Part of HYC2314S01).
Doc003328.png
To Next Page
Loading...