Master Language is English Hot Runner System Installation Guide SVC-17-0001_EN-Rev13
RESTRICTED: Property of Synventive. - 93 - All rights reserved. Errors and omissions excepted
For limited third party distribution based on need and intended use. © 2021 Synventive Molding Solutions
H O T R U N N E R T E C H N O L O G Y
Hot Runner System Installation Guide
Service and Maintenance / Actuator HB Series
2) Remove piston (E) and cap (F) with a valve
pin.
Doc008518.png
3) Separate piston (E) from cap (F).
Doc008505.png
4) Use tools T15.1 and T15.2 to disassemble the
piston cap PC02 from PC01.
5) Remove Rod Seal 1.4.
Doc008506.png
To Next Page
Loading...